 |
|
| |
|
|
| Step one is to take our bread
box and figure out where we want to place our power
source. We want to try to keep this looking visually
pleasing. Another thing to think about is where
the heat sources will be. The bulb and the inverters
will put out some heat, but ultimately the brick
is the highest heat producer. |
|
|
| In the back of this breadbox we
drilled a 9/16ths hole so that we could install
a internal extension plug to the bulb. |
|
|
| Next up is to take our male and
female plug ends and solder an 8 inch wire between
then. Using a small amount of heat shrink tubing
make sure the ends of the plug jack are insulated
well. |
|
|
| Finally install the plug extender
in the back of the box. Use the small nut that it
came with to secure firmly the jack in the back. |
|
|
|
|
