 |
|
 |
|
| |
| |
So here is our turret unboxed. It’s a fairly simple 3 function device consisting of up - down, left - Right, and fire - fired. so step one is to use a slightly maniacal laughter at the little foam "missiles" knowing what type of firepower this would be capable of when you’re done. |
| |
So step one of disassembly is to remove the bottom plate from the USB missile turret. There are 3 screws under the rubber feet that will allow you to gain access to its wire stroon innards. Once you have the unit open you will have to remove the motor module to expose the 3 screws in the large white gear holding the upper section to the lower. |
|
With the screws to the white gear removed you will have to remove the screws holding on the second motor module to the upper turret module to gain access to the screws holding the launcher in place. |
|
With the second motor module removed you can clearly see the 4 screws holding the launcher section to the upper portion of the turret. |
|
With the 4 screws removed you will have 2 mounting plates fall aside and the upper launcher will come loose. Don’t loose or misplace those 2 small mounting plates! Once you have freed the launcher cut the wires in the middle of their length so you can reattach them later. And set the turret base aside. |
|
Next step is to remove the 2 screws in the back of the launcher to expose the motor for firing control and the wire leading to the sensor for firing.
|
|
|
|
|
